ACKOBOM:The oiling tutorial for FTMSTP products is as follows

ACKOBOM:The oiling tutorial for FTMSTP products is as follows

Tools required:
The finest syringe
Specialized silicone oil
STP (smooth skin)
Steps:
Find the middle layer of the product:
Gently pull the outer layer of the product apart to find the inner middle layer, which is usually where the silicone oil needs to be injected.
Drawing silicone oil:
Using the finest syringe, draw an appropriate amount of special silicone oil. Make sure there are no bubbles in the syringe and have enough silicone oil ready for injection.
Injecting silicone oil:
Insert the needle of the syringe into the middle layer and carefully and slowly inject the silicone oil. Inject slowly to ensure that the silicone oil is evenly distributed and does not rupture the outer layer.
Adjust the injection amount according to the desired effect. If greater mobility is required, more silicone oil can be injected. After each injection, gently massage the surface to help the silicone oil evenly distribute.
Multiple injections:
If the product requires more silicone oil to allow the skin to move freely, you can repeat the injection several times until the desired flexibility is achieved.
Don't inject too much at one time to avoid rupture or too much silicone oil causing unnatural results.
Complete the injection:

After the injection, make sure the silicone oil is completely in the middle layer of the product without air bubbles and allow it to be fully absorbed. Depending on the design of the product, you may need to gently press or perform other auxiliary operations to help the silicone oil be evenly distributed.
Check the mobility:

Test the mobility of the STP to ensure that the skin part can be moved and adjusted flexibly. If it feels not flexible enough, you may need to inject a small amount of silicone oil again.
Note:

When injecting, try to avoid excessive pressure or violent operation to prevent damage to the product.
The amount of silicone oil should be adjusted according to personal needs, and be careful when injecting to ensure the best use effect.
This tutorial is suitable for STP (smooth skin) products, which can improve the mobility and comfort of the skin.